when i use M119 Command in Pronterface it doesn't detect the motor drivers.
SENDING:M122
X Y Z E
Address 0 0 0 0
Enabled false false false false
Set current 760 760 760 900
RMS current 1325 1325 1325 1602
MAX current 1868 1868 1868 2259
Run current 23/31 23/31 23/31 28/31
Hold current 11/31 11/31 11/31 14/31
CS actual 0/31 0/31 0/31 0/31
PWM scale 0 0 0 0
vsense 0=.325 0=.325 0=.325 0=.325
stealthChop false false false false
msteps 256 256 256 256
tstep 0 0 0 0
pwm
threshold 1581 1581 10541 4534
[mm/s] 100 100 3 30
OT prewarn false false false false
OT prewarn has
been triggered false false false false
off time 0 0 0 0
blank time 16 16 16 16
hysteresis
-end -3 -3 -3 -3
-start 1 1 1 1
Stallguard thrs 50 50 0 0
DRVSTATUS X Y Z E
stst
olb
ola
s2gb
s2ga
otpw
ot
157C
150C
143C
120C
s2vsa
s2vsb
Driver registers:
X 0x00:00:00:00 Bad response!
Y 0x00:00:00:00 Bad response!
Z 0x00:00:00:00 Bad response!
E 0x00:00:00:00 Bad response!
Testing X connection... Error: All LOW
Testing Y connection... Error: All LOW
Testing Z connection... Error: All LOW
Testing E connection... Error: All LOW