I can't find any information in how to install the TMC2209 to Marlin/RAMPS 1.4. I tried wiring it up with "y" cables from the RX to the UART pins but it does not work, when I do a M122 the output below, could someone please point me in the right direction? Thank you!
SENDING:M122
X Y Z E0
Enabled false false false false
Set current 600 800 600 600
RMS current 1049 1436 1049 1049
MAX current 1479 2025 1479 1479
Run current 18/31 25/31 18/31 18/31
Hold current 9/31 12/31 9/31 9/31
CS actual 0/31 0/31 0/31 0/31
PWM scale 0 0 0 0
vsense 0=.325 0=.325 0=.325 0=.325
stealthChop false false false false
msteps 256 256 256 256
tstep 0 0 0 0
pwm
threshold 1581 1581 10541 1016
[mm/s] 100.02 100.02 3.00 30.00
OT prewarn false false false false
OT prewarn has
been triggered false false false false
off time 0 0 0 0
blank time 16 16 16 16
hysteresis
-end -3 -3 -3 -3
-start 1 1 1 1
Stallguard thrs
DRVSTATUS X Y Z E0
stst
olb
ola
s2gb
s2ga
otpw
ot
157C
150C
143C
120C
s2vsa
s2vsb
Driver registers: X = 0x00:00:00:00
Y = 0x00:00:00:00
Z = 0x00:00:00:00
E0 = 0x00:00:00:00