Hi everybody, I have a setup with S6, TMC 2209 V3.0, MKS mini12864 and dual Y stepper and driver.
I've setup Stallguard and Sensorless Homing for all axis.
Sensorless Homing work well for X,Y and Y2, but I can't get it to work on Z.
I've tried allmost every settings of sensitivity, current, and speed.
I've tried to switch motor and driver with no luck.
Diag pin of TMC is well connected to Zmin signal, and Zmin work well when I put it to Vcc.
It seem that diag pin on Z doesn't send proper command.
Any advice ?