Hello, I connect tft81050 to the board fesetc s6 but the screen does not glow.
You need external Power to the TFT
Hi im new there.
I buy a TFT81050 LCD but i didnt found information about how to update and download the frimeware and how to connect if on my F6 mainboard.
For this time i tried to connect it on EXP1 or 2 with external power but nothing works.
Have you an idea?
Thanks for your help.
This screen not tested on F6 board. Currently only works with S6 board. But theoretically it can be support by F6 board , you can try to enable TOUCH_UI_FTDI_EVE and follow our wiki to compile the firmware https://wiki.fysetc.com/F6_V1.3/
Thanks for your return GeorgeFu. I will look the wiki
Now FT81050 is supported in FYSETC F6
You need to enable following in configuration.h
and following setting in configuration_adv.h
PR is here: https://github.com/MarlinFirmware/Marlin/pull/18678
Then you need to follow our wiki to compile the firmware and upload
I have follow the wiki and that what you give as instruction, but the TFT81050 doesnt work on my F6 mainboard.
The curious thing is that the back light doesnt go on on TFT. For me, i think the TFT is defective.
GoergeFu Can you confirme me this?
Did you close the jumper ?
the jumper is between 1 and 2 too have +5V on pin 1
JackyBurget Close TBD and 5v , you can see it at the backside
I have done it and made the configuration you indicate but the screen is always dark.
I have a question. Is there a link where i can donwload the screen firmware for TFT81050 V1.0?
JackyBurget Screen don't need firmware itself. It's drived by the motherboard
Thanks for your answer.
Its what i have made but screen is always dark no back ground led is on.
Have you an idea?
Ok i unterstand this for thr firmware. But for the screens design how to modify them or update them?