Hello, I connect tft81050 to the board fesetc s6 but the screen does not glow.
You need external Power to the TFT
Hi im new there. I buy a TFT81050 LCD but i didnt found information about how to update and download the frimeware and how to connect if on my F6 mainboard. For this time i tried to connect it on EXP1 or 2 with external power but nothing works. Have you an idea? Thanks for your help.
This screen not tested on F6 board. Currently only works with S6 board. But theoretically it can be support by F6 board , you can try to enable TOUCH_UI_FTDI_EVE and follow our wiki to compile the firmware https://wiki.fysetc.com/F6_V1.3/
Thanks for your return GeorgeFu. I will look the wiki
Now FT81050 is supported in FYSETC F6 You need to enable following in configuration.h #define TOUCH_UI_FTDI_EVE and following setting in configuration_adv.h #define LCD_FYSETC_TFT81050 #define F6_TFT_PINMAP PR is here: https://github.com/MarlinFirmware/Marlin/pull/18678
Then you need to follow our wiki to compile the firmware and upload https://wiki.fysetc.com/F6_V1.3/
I have follow the wiki and that what you give as instruction, but the TFT81050 doesnt work on my F6 mainboard. The curious thing is that the back light doesnt go on on TFT. For me, i think the TFT is defective.
GoergeFu Can you confirme me this?
Did you close the jumper ?
the jumper is between 1 and 2 too have +5V on pin 1 Its rigth?
JackyBurget Close TBD and 5v , you can see it at the backside
I have done it and made the configuration you indicate but the screen is always dark.
I have a question. Is there a link where i can donwload the screen firmware for TFT81050 V1.0?
JackyBurget Screen don't need firmware itself. It's drived by the motherboard
Thanks for your answer. Its what i have made but screen is always dark no back ground led is on. Have you an idea?
Ok i unterstand this for thr firmware. But for the screens design how to modify them or update them?
Hi GeorgeFU I have buy a Fysetc S6 board and verify if the first TFT81050 works but it wasnt. I received another TFT81050 and tested it on the FYSETC S6 with marlin 2.0.6 and that works fine. configuration used on for S6 board was:
But on the FYSETC F6 V1.3 with the same version of Marlin 2.0.6 that doesnt work
i forgot on F6 board i plug the jumper to close TBD and 5v (JP4)
Oh,finally you make it. Good job.
yes it works with the Fysetc S6 board,
But at this point the TFT81050 doesnt work with the FYSETC F6 V1.3 board.
Did you use the latest bugfix 2.0 firmware? And You need to enable following in configuration.h #define TOUCH_UI_FTDI_EVE and following setting in configuration_adv.h #define LCD_FYSETC_TFT81050 #define F6_TFT_PINMAP And use Arduino to compile the firmware, please follow the firmware part of our wiki: https://wiki.fysetc.com/F6_V1.3/ And if the screen did not light up, you can try to inverse the cable 180 degree