Hi I tried to compiled the FW and uploaded it via SD (according to your wiki https://wiki.fysetc.com/FYSETC_S6/#firmware). But I ended up with a board cycling in watchdog reset soon after start. I didn't even try to modify the Configuration.h file. Just as it is in FYSETC git. I have a bare board, no motor drivers so far. Only SD card and Display (from Ender 3) that shows boot logo and then the board resets. If I try to disable the watchdog the boards keeps running I can connect via usb serial, I can browse the menu via the display. But I can't do much. If I connect a temperature sensor it still reports 1 degree. If I connect a motor driver the motor just gets energized, but does not move (or at least make some noise). I tried Polulu (A4988) and TMC2208 both with same results.
Do you have any idea, suggestion how to easy debug, find out what's wrong and fix it?
Moreover I moved recently and I have no idea where my stlinkv2 ended so at the moment I can't connect to the swd port and debug/step through the code.