Extruder has stopped working

Roswell36

Hi, I have an F6 board with TMC2130 drivers. My extruder stopped working on. I have swapped out the driver for a new one but still get the same problem. Everything else is working fine including the BL Touch. I have re-uploaded the firmware and still no success. Can you help?

Dai

First make sure that the 2130 driver you are using is correct.
https://github.com/FYSETC/F6/tree/master/F6%20Test%20firmware
This is a test firmware. You only need to connect the power supply, drive and motor, disconnect the hot bed and hotend or others. When you turn on the power, the firmware will control the motor to rotate automatically. If you use this test firmware to test the motor is no problem, then you can determine that there is no problem on the motherboard hardware.