I'm a newbie and trying to use this driver for my DIY project where I could use sensorless homing.
Basically, I'm trying to tune this but what I'm doing is connecting it to the windows PC with the FTDI232RL breakout board with the Waterott Configurator through Scriptcommuncator and putting values to tune (such as SGTHRS, StallGuard Threshold) then disconnecting it and putting it on my breadboard to see if it gives me any output from DIAG when I stall the motor. I'm using a raspberrypi as the controller and using the STEP/DIR interface.
So, do these tuning values get reset after a shutdown?
Any help would be appreciated;
Thanks!