Fysetc S6 V2.0

maralb

The S6 V2.0 is going to be released in the nearby future. What are the updates and differences in respect to the S6 V1.2?

GeorgeFu

Wait for our news, it's coming soon.^^

maralb

Thank you George..... As far as I can judge on the pictures and the pins file for Fystec S6 V2.0

Some pins have been reassigned for TMC UART and SPI TMC2130
There seems to be power options by jumpers (powering by USB??) but I might be wrong about this.
Boot0 button is removed - V2.0 describes now updating firmware by SD card. V1.2 in DFU mode by STM link which can be nasty when the board is installed in a 3D printer.
external EEPROM standard in V2.0. My S6 V1.2 does have external I^2C Eeprom (24LC16 16kbit/2kbyte) but it seems the first iterations of the S6 V1.2 do not have any external EEPROM installed.

I will wait for the news :-)

Jan78

maralb There seems to be power options by jumpers (powering by USB??) but I might be wrong about this.
Boot0 button is removed - V2.0 describes now updating firmware by SD card. V1.2 in DFU mode by STM link which can be nasty when the board is installed in a 3D printer.

There is indeed a jumper for 5V USB Power/Powersupply.
The boot0 button is removed, It´s a 3 pin header now. You can get into DFU mode by shorting 2 pins with a jumper.

GeorgeFu

I already make the PR for v2.0, so you can have a look at the latest marlin.

Jan78

Aliexpress sent me a v2 board by mistake but it isnt working right. Reflashed bootloader and firmware but display not working. Any help..?

devdav

Jan78 I just discovered the manual is wrong, it says you need to short the middle with the GND and in the picture the GND is shown as the one to the right (above the S6 logo), but you need to short it with the one to the left of it, which is labelled as 3.3V... go figure

GeorgeFu

Thanks for your infomation , i will update the README

GeorgeFu

Done , next time you can make PR for us if you will , thanks in advance. https://github.com/FYSETC/FYSETC-S6/pulls