I'm trying to get TMC2225 from FYSETC to work in UART mode on an SKR 1.4 turbo card, but there is always tmc connection error.
I've researched everything on the internet and I couldn't solve it. I would like help here to solve this problem.
ENVIADO: M122
LIDO: axis:pwm_scale/curr_scale|flags|warncount
LIDO: X Y Z E
LIDO: Enabled false false false false
LIDO: Set current 800 800 800 800
LIDO: RMS current 1436 1436 1436 1436
LIDO: MAX current 2025 2025 2025 2025
LIDO: Run current 25/31 25/31 25/31 25/31
LIDO: Hold current 12/31 12/31 12/31 12/31
LIDO: CS actual 0/31 0/31 0/31 0/31
LIDO: PWM scale
LIDO: vsense 0=.325 0=.325 0=.325 0=.325
LIDO: stealthChop false false false false
LIDO: msteps 256 256 256 256
LIDO: tstep 0 0 0 0
LIDO: PWM thresh. 1581 1581 21083 8267
LIDO: [mm/s] 100 100 3 30
LIDO: OT prewarn false false false false
LIDO: triggered
LIDO: OTP false false false false
LIDO: pwm scale sum 0 0 0 0
LIDO: pwm scale auto 0 0 0 0
LIDO: pwm offset auto 0 0 0 0
LIDO: pwm grad auto 0 0 0 0
LIDO: off time 0 0 0 0
ENVIADO: M105
LIDO: blank time 16 16 16 16
LIDO: hysteresis
LIDO: -end -3 -3 -3 -3
LIDO: -start 1 1 1 1
LIDO: Stallguard thrs
LIDO: uStep count 0 0 0 0
LIDO: DRVSTATUS X Y Z E
LIDO: sg_result
LIDO: stst * * * *
LIDO: olb
LIDO: ola
LIDO: s2gb
LIDO: s2ga
LIDO: otpw
LIDO: ot
LIDO: 157C
LIDO: 150C
LIDO: 143C
LIDO: 120C
LIDO: s2vsa
LIDO: s2vsb
LIDO: Driver registers:
LIDO: X 0x00:00:00:00 Bad response!
LIDO: Y 0x00:00:00:00 Bad response!
LIDO: Z 0x00:00:00:00 Bad response!
LIDO: E 0x00:00:00:00 Bad response!
LIDO:
LIDO:
LIDO: Testing X connection... Error: All LOW
LIDO: Testing Y connection... Error: All LOW
LIDO: Testing Z connection... Error: All LOW
LIDO: Testing E connection... Error: All LOW