Hi everyone, so...
Just installed the motherboard and seems fine...except can't get the blTouch to wor...
Tried using the default config files for Bltouch....but not much luck, it's blinking after self test (better than out of the box where it was just blinking and can't be controlled)
No need to say , but the Bltouch wxas working onehour before switching the motherboard.
Tried to reverse White / Black Green bu its worse , as Z go down and Touch don't even try to deploy.
Same time...Can't get the button of LCD Screen working. (I can push it...but it doesn't move when turn left or right)
Every part was stock Ender 3
Pretty sure there is some thing to change on the firmware (as...in marlin 1.1.9 i had to set #define SERVO0_PIN27 ...nothing like that in this one?!)
Someone to give help?